New Moro kris

kai · 12th February 2020, 11:45 AM

A lot of reasonable advice - we need pics/close-ups though to fine-tune any recommendations!

kai · 12th February 2020, 12:15 PM

Hello Apolaki,

Please verify whether the thin metal strips (which attach the clamps to the hilt) run under the grip binding or entering into the wooden core of the hilt (together with the tang and resin).

If the latter, heating the blade will allow you to remove the hilt and then the clamps (and reassemble everything after restoration). This will greatly ease working on the blade!

If the former and bindings are tight, the metal strips can sometimes be removed from the clamps (tends to be tricky if at all possible) and the hilt/clamps removed, too.

Otherwise, you're out of luck and need to invest in lots of patience and elbow grease...

Regards,
Kai

12th February 2020, 11:45 AM	#1
kai Member Join Date: Apr 2005 Posts: 3,255	A lot of reasonable advice - we need pics/close-ups though to fine-tune any recommendations!

12th February 2020, 12:15 PM	#2
kai Member Join Date: Apr 2005 Posts: 3,255	Hello Apolaki, Please verify whether the thin metal strips (which attach the clamps to the hilt) run under the grip binding or entering into the wooden core of the hilt (together with the tang and resin). If the latter, heating the blade will allow you to remove the hilt and then the clamps (and reassemble everything after restoration). This will greatly ease working on the blade! If the former and bindings are tight, the metal strips can sometimes be removed from the clamps (tends to be tricky if at all possible) and the hilt/clamps removed, too. Otherwise, you're out of luck and need to invest in lots of patience and elbow grease... Regards, Kai