How to clean rust over gold or silver

Helleri · 2nd September 2017, 12:05 PM

I think you mean gold-tone. Gold is 99.8% chemically inert. True gold does not tarnish or rust under normal circumstances (it pretty much takes a laboratory). A gold coin in burnt and salted earth under a pile of corpses in a mass grave of an ancient raided village would look like newly minted pulled out of the ground 2000 years later. Gold also tends to be rather slick. SO any grime collected in deep crevices is not likely to be bound to it's surface through something like galvanic corrosion which effect lesser noble metals. It's merely cradling it and it should wipe clean with dry soft bristled brushing.

As for true silver. Wood ash and warm water. 1:1 ratio mixed into a slurry and a soft bristle brush. Flushing away the slurry afterward can be a bit annoying and a careful process depending on the nature of a piece. If that is a concern let it first dry fully (and naturally with no applied heat) and then dry brush it away. Nothing will reveal it's prime luster better.

But really I wouldn't personally want to do much more to silver then to dry buff it. As it is at it's most beautiful with a nice patina. A characteristic that tends to raise value in all respects.

Kubur · 9th September 2017, 11:26 AM

Hi Guys

Thank you all for your help
Here is the maximum that I can do.
I didn't want to go too far as there are bits of gold everywhere...

Kubur

9th September 2017, 11:26 AM	#2
Kubur Member Join Date: Jun 2013 Posts: 2,145	Hi Guys Thank you all for your help Here is the maximum that I can do. I didn't want to go too far as there are bits of gold everywhere... Kubur Attached Images

2nd September 2017, 12:05 PM	#1
Helleri Member Join Date: Jan 2016 Location: Chino, CA. Posts: 219	I think you mean gold-tone. Gold is 99.8% chemically inert. True gold does not tarnish or rust under normal circumstances (it pretty much takes a laboratory). A gold coin in burnt and salted earth under a pile of corpses in a mass grave of an ancient raided village would look like newly minted pulled out of the ground 2000 years later. Gold also tends to be rather slick. SO any grime collected in deep crevices is not likely to be bound to it's surface through something like galvanic corrosion which effect lesser noble metals. It's merely cradling it and it should wipe clean with dry soft bristled brushing. As for true silver. Wood ash and warm water. 1:1 ratio mixed into a slurry and a soft bristle brush. Flushing away the slurry afterward can be a bit annoying and a careful process depending on the nature of a piece. If that is a concern let it first dry fully (and naturally with no applied heat) and then dry brush it away. Nothing will reveal it's prime luster better. But really I wouldn't personally want to do much more to silver then to dry buff it. As it is at it's most beautiful with a nice patina. A characteristic that tends to raise value in all respects.