Mandaya Dagger

[kai]

Hello Robert,

Thanks for showing!

Without any corroborating evidence that I know of, I'd be inclined to believe that these plain and smaller examples are more likely to be for people of somewhat lesser status: I'd expect early pieces of high status leaders to show at least better carving quality than seen with these examples...

AFAIK, there is also no shortage of silver with early antique jewellery - thus, I see no reason why the more embellished examples should not be at least as old; their workmanship is certainly of high quality.

Regards,
Kai

[Jim McDougall]

Interesting dagger, and Ibrahiim thank you for the historical input and link. For those like myself who have little familiarity with these, it is great to have this kind of perspective to learn more on them. I honestly would never have known this was from the Philippines, and its good to know more on its features. Much appreciated.

[Battara]

Nice job Robert and congratulations on getting a Mandaya knife.

Until recently I did not know how hard it was to get one of these. Part of the problem is that the scabbard wood seems to be made of a soft wood and may not survive.

Early examples vs lower status examples not having any silver - I don't know for sure. Not much evidence if any exists regarding early examples. What has been an established pattern (for the most part) is that upper status pieces seem to get the silver treatment.

[Robert]

great work you have done so far on this little fellow. To glue the hilt without removing the rattan braiding was for sure a challenge, congrats!

Thank you for your kind comment on this part of the restoration work on this piece. I must admit that it had taken me quite a few hours of head scratching to finally figure out how to re-align and hold the three broken sections of the hilt together, glue them back into one piece and keep them aligned until the glue had adequate time to dry all without causing damage to or making a complete disaster of the rattan wrapping. Though there is still much work to be done I am very pleased with how it has turned out so far.

Kai, I am not saying that the older higher end examples were not decorated. I was only pointing out that the pieces that I could locate that did have some provenance on when they were collected the ones collected earlier dating to the 19th century all appeared to be of a smaller size and less decorative than the ones collected in the 20th century. I only used the gunong as an example as they seemed to have evolved in their appearance in the same way. Earlier examples look smaller and less decorative than their later counterparts.

Jim, Thank you for your interest and comments on these unusual and rare daggers. I personally became most interested in them when I was preparing to do the restoration work on one of Detlef's examples before it arrived.

Jose, Thank you for your kind words as well. Like you I never knew just how hard it was to acquire one of these until I decided I needed one for my personal collection. All were either too expensive, already sold or in absolutely terrible condition well beyond my poor ability to help.

[Kingforge]

Hello, Judd King here, I have recently come into possession of a mandaya dagger, I see that this thread is several years old but is by far the most relevant. I found this online and had to wait a week to pick it up, I did a bit of research while waiting, thinking that I would miss out on this great find, my patience paid off. I do currently have the dagger on etsy, but would appreciate any help I can find here. The blade is in need of some minor restoration, and this seems to be the place. Thanks in advance.

[Ian]

Welcome kingforge. Please post pictures of the item.

[Kingforge]

Here are a few pics