Keris pamor

A. G. Maisey · 8th August 2015, 10:56 PM

I wouldn't say "brand new" Henk, this type of Madura work has been around since at least the 1985. There was similar stuff done in Madura, and maybe East Jawa, in the early 20th century through to WWII, but not a lot of it, so its unlikely to be from that earlier period.

The little bit of rust on these blades is negligible, and not a cause for even the slightest concern, it can be cleaned off with patience, penetrating oil, a hard toothbrush, and a few strands of 00 steel wool wound around the end of a wooden sate skewer.

Quality of these two blades? Pretty ordinary. Certainly not bad, but also certainly not exceptional. FAQ.

Rather than focus on how good, bad, or indifferent the pamor is, I would suggest that garap should be given precedence in blade appraisal, with well executed pamor, if present, being a nice little extra.

8th August 2015, 10:56 PM	#12
A. G. Maisey Member Join Date: May 2006 Posts: 7,019	I wouldn't say "brand new" Henk, this type of Madura work has been around since at least the 1985. There was similar stuff done in Madura, and maybe East Jawa, in the early 20th century through to WWII, but not a lot of it, so its unlikely to be from that earlier period. The little bit of rust on these blades is negligible, and not a cause for even the slightest concern, it can be cleaned off with patience, penetrating oil, a hard toothbrush, and a few strands of 00 steel wool wound around the end of a wooden sate skewer. Quality of these two blades? Pretty ordinary. Certainly not bad, but also certainly not exceptional. FAQ. Rather than focus on how good, bad, or indifferent the pamor is, I would suggest that garap should be given precedence in blade appraisal, with well executed pamor, if present, being a nice little extra.