Afghan Jezail in York, UK

RDGAC · 30th March 2010, 09:04 PM

Ahh, I see. Yet another term to add to my collection... I'm 99% certain this piece isn't damascus steel, though until I do remove the barrel and de-rust it, obviously I can't be completely sure. Having removed the foremost two barrel bands, however, I have had chance to look at an area of the gun that is largely corrosion-free, and cannot spot any obvious Damascus pattern. I note you say, Ward, that acid is used to bring out the pattern; I'm going to go out on a limb here, and guess that this is not something one should try at home?

And Jim... aw shucks, thanks

I do try to keep an open mind... besides which, I committed the cardinal sin, only a few months ago, of polishing the fittings on a Japanese sword; fortunately, they were standard, mass-produced, Type 94 Shin-gunto fittings, but still. Only when someone patiently explained to me that Japanese craft objects tend to make extensive use of patination did it suddenly dawn on me that, but for blind luck, I could have destroyed the work of some forgotten craftsman. Since then I've become supremely cautious about doing anything with anything outside of my direct areas of study, and very eager indeed to get hold of as much knowledge as I can about them. One can't care for something of which one knows nothing as well as one could if one knew, no?

30th March 2010, 09:04 PM	#1
RDGAC Member Join Date: Mar 2010 Location: York, UK Posts: 167	Ahh, I see. Yet another term to add to my collection... I'm 99% certain this piece isn't damascus steel, though until I do remove the barrel and de-rust it, obviously I can't be completely sure. Having removed the foremost two barrel bands, however, I have had chance to look at an area of the gun that is largely corrosion-free, and cannot spot any obvious Damascus pattern. I note you say, Ward, that acid is used to bring out the pattern; I'm going to go out on a limb here, and guess that this is not something one should try at home? And Jim... aw shucks, thanks I do try to keep an open mind... besides which, I committed the cardinal sin, only a few months ago, of polishing the fittings on a Japanese sword; fortunately, they were standard, mass-produced, Type 94 Shin-gunto fittings, but still. Only when someone patiently explained to me that Japanese craft objects tend to make extensive use of patination did it suddenly dawn on me that, but for blind luck, I could have destroyed the work of some forgotten craftsman. Since then I've become supremely cautious about doing anything with anything outside of my direct areas of study, and very eager indeed to get hold of as much knowledge as I can about them. One can't care for something of which one knows nothing as well as one could if one knew, no? Last edited by RDGAC; 30th March 2010 at 11:31 PM.