VOC hanger advice

asomotif · 18th November 2021, 08:01 PM

Interesting sword.

I would leave the metal as it is. Crystalline wax sounds good.

The hilt. It would be nice if someone could reshape it into a thinner spiral hilt without removing it. A smart carver should be able to do this.

I am very surprised about the crisp markings on the "left" side.
But as left and right are the same stamps and on the right side they show erosion that is more consistent, I find it hard to draw a conclusion.

Best regards,
Willem

18th November 2021, 08:01 PM	#11
asomotif Member Join Date: Nov 2006 Location: The Netherlands Posts: 2,228	Interesting sword. I would leave the metal as it is. Crystalline wax sounds good. The hilt. It would be nice if someone could reshape it into a thinner spiral hilt without removing it. A smart carver should be able to do this. I am very surprised about the crisp markings on the "left" side. But as left and right are the same stamps and on the right side they show erosion that is more consistent, I find it hard to draw a conclusion. Best regards, Willem