Bali Keris #3

GIO · 12th June 2014, 05:27 PM

When I clean and etch a blade I always remove the ganja to eliminate the rust. I then cover all parts in contact between blade and tang with a rust converter to avoid future problems.
In the self-explicating drawing you can find the method I use to remove and re-fit the ganja. If possible I avoid using glue of any sort.
Be very careful and delicate to avoid any damage, especially when you place the blade in the vice: it must be very firm, so place two pieces of wood on both sides of the blade and close with strength the vice.
Good work !

12th June 2014, 05:27 PM	#16
GIO Member Join Date: Dec 2009 Posts: 331	When I clean and etch a blade I always remove the ganja to eliminate the rust. I then cover all parts in contact between blade and tang with a rust converter to avoid future problems. In the self-explicating drawing you can find the method I use to remove and re-fit the ganja. If possible I avoid using glue of any sort. Be very careful and delicate to avoid any damage, especially when you place the blade in the vice: it must be very firm, so place two pieces of wood on both sides of the blade and close with strength the vice. Good work ! Attached Images