Moro Punal Info please

imas560 · 25th September 2013, 04:50 AM

thanks Battara

imas560 · 19th October 2013, 03:53 AM

So I finally got time to clean the punal up a little. I started on the blade with 0000 steel wool and balistol oil. On each side there is what appears to be a copper insert. Also where I was cleaning at the base of the blade the hilt/guard appears to be similar to copper. Was wondering if I had gone too far with the hilt/guard and started removing what might be a silver wash?
Any suggestions/recommendations greatly appreciated.

Battara · 20th October 2013, 05:06 AM

May have been silver wash - not unusual for this recent type and very little silver in that wash. Wouldn't worry about it.

imas560 · 20th October 2013, 07:06 AM

Thanks Battara

19th October 2013, 03:53 AM	#2
imas560 Member Join Date: Aug 2010 Posts: 180	oh poop So I finally got time to clean the punal up a little. I started on the blade with 0000 steel wool and balistol oil. On each side there is what appears to be a copper insert. Also where I was cleaning at the base of the blade the hilt/guard appears to be similar to copper. Was wondering if I had gone too far with the hilt/guard and started removing what might be a silver wash? Any suggestions/recommendations greatly appreciated. Attached Images

25th September 2013, 04:50 AM	#1
imas560 Member Join Date: Aug 2010 Posts: 180	thanks Battara

20th October 2013, 05:06 AM	#3
Battara EAAF Staff Join Date: Dec 2004 Location: Louisville, KY Posts: 7,272	May have been silver wash - not unusual for this recent type and very little silver in that wash. Wouldn't worry about it.

20th October 2013, 07:06 AM	#4
imas560 Member Join Date: Aug 2010 Posts: 180	Thanks Battara