My eBay Venture

dbhmgb · 5th May 2012, 07:44 PM

Here's the original hilt - it's really not quite ready, but you can see the improvement.

Greybeard - thanks! I feel fortunate to have won this keris!

For cleaning I use a fine grade steel wool and work out all the imperfections, then is use light coat of a very light stain with polyurethane. When that dries I use a high grade wood oil and let that soak in. The results are usually good.

The blade is just pineapple juice, stiff brushes and fine grade steel wool.

Greybeard · 5th May 2012, 08:38 PM

Dan, now I'm really tempted to try pinapple juice instead of my usual deluted vinegar -- your results are just too good!

dbhmgb · 5th May 2012, 09:34 PM

Quote:

Originally Posted by Greybeard

Dan, now I'm really tempted to try pinapple juice instead of my usual deluted vinegar -- your results are just too good!

I have to be honest, I'm shocked at the results (plus very pleased)!

asomotif · 5th May 2012, 10:44 PM

Nice job !

I like the mendak. looks almost like suasa

David · 6th May 2012, 01:33 AM

Quote:

Originally Posted by asomotif

I like the mendak. looks almost like suasa

I'd say that is unlikely given how tarnished it was at the beginning. More likely copper or brass.

dbhmgb · 6th May 2012, 03:37 AM

Quote:

Originally Posted by David

I'd say that is unlikely given how tarnished it was at the beginning. More likely copper or brass.

You're right! It's copper...

Rick · 6th May 2012, 04:36 AM

If I may give a bit of advice as a retired Finisher about your Jogja hilt and scabbards in general .

These urethane/stain combinations are bad for achieving a finish that would be acceptable within the culture .

I would suggest either some form of 'Lac' finish, or failing that , tung or gunstock oil; Watco oil is also an option .

I would strongly advise against using any artificial/plastic formula for finish .

5th May 2012, 07:44 PM	#1
dbhmgb Member Join Date: Apr 2012 Location: Maryland, USA Posts: 112	Here's the original hilt - it's really not quite ready, but you can see the improvement. Greybeard - thanks! I feel fortunate to have won this keris! For cleaning I use a fine grade steel wool and work out all the imperfections, then is use light coat of a very light stain with polyurethane. When that dries I use a high grade wood oil and let that soak in. The results are usually good. The blade is just pineapple juice, stiff brushes and fine grade steel wool. Attached Images

5th May 2012, 08:38 PM	#2
Greybeard Member Join Date: May 2009 Location: Switzerland Posts: 124	Dan, now I'm really tempted to try pinapple juice instead of my usual deluted vinegar -- your results are just too good!

5th May 2012, 10:44 PM	#4
asomotif Member Join Date: Nov 2006 Location: The Netherlands Posts: 2,237	Nice job ! I like the mendak. looks almost like suasa

6th May 2012, 04:36 AM	#7
Rick Vikingsword Staff Join Date: Nov 2004 Posts: 6,378	If I may give a bit of advice as a retired Finisher about your Jogja hilt and scabbards in general . These urethane/stain combinations are bad for achieving a finish that would be acceptable within the culture . I would suggest either some form of 'Lac' finish, or failing that , tung or gunstock oil; Watco oil is also an option . I would strongly advise against using any artificial/plastic formula for finish .