![]() |
|
![]() |
#1 |
Member
Join Date: Dec 2004
Location: Santa Barbara, California
Posts: 301
|
![]()
they had a few others in there, including one that has been sanded so badly that all the pamor was gone. (Sigh.) this one at least was in pretty fair condition. Thank you, Alan, for your no nonsense explanation on how to wash it with detergent and a toothbrush and give it some WD-40. Yes, the scabbard fits perfectly.
|
![]() |
![]() |
![]() |
#2 |
Member
Join Date: May 2006
Posts: 6,856
|
![]()
Yes Montino, simple things sometimes work best.
I think this keris is likely to tangguh Tuban. |
![]() |
![]() |
![]() |
#3 |
Member
Join Date: Aug 2007
Location: Germany, Dortmund
Posts: 8,732
|
![]()
Hello Montino,
You should polish up the brass pendok (over sheath). Pamor is wos wutah. Regards, Detlef |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Sep 2005
Location: Singapore
Posts: 322
|
![]()
I like it.
|
![]() |
![]() |
![]() |
#5 | |
Keris forum moderator
Join Date: Aug 2006
Location: Nova Scotia
Posts: 7,100
|
![]() Quote:
I might even consider replacing the somewhat worn out mendak if i really wanted to spiff-up this ensemble. ![]() |
|
![]() |
![]() |
![]() |
#6 |
Member
Join Date: May 2006
Posts: 6,856
|
![]()
Dirty old mendak respond well to a couple of hours in a white vinegar soak, brush well under running water, dry.
|
![]() |
![]() |
![]() |
#7 |
Keris forum moderator
Join Date: Aug 2006
Location: Nova Scotia
Posts: 7,100
|
![]() |
![]() |
![]() |
![]() |
#8 |
Member
Join Date: May 2006
Posts: 6,856
|
![]()
That beadwork can drop off even on new mendak, its not a big deal, & this mendak has a bit of age & appears to be complete & overall OK. I'd stick with this one --- if it did not come apart when it is taken off the keris.
The out of kilter "thing is usually due in poor mating of the mendak with the bottom of the handle, if the handle has a recess intended to accept the mendak, that recess might need to be made a whisker wider, if it is a flat bottom it might need to be levelled, sometimes the problem can be with the tang, use alloy jaw liners, put the tang into a vice, very gently bend the tang to the appropriate angle --- if it is a cold day warm the tang. A mendak should always be test mated to the hilt before mounting to the tang. |
![]() |
![]() |
![]() |
|
|