Folding Knife

ingelred · 3rd May 2009, 02:23 PM

Hello Gav,

sorry for not showing You the picture I refer to but I have very little time at the moment.
Concerning slip joint, okay, let's call it simple back spring.
I have also a Albacete made Navaja with a simple back spring and no real locking system.
This back spring holds up on the handle which is made one-piece, so no second pin for the back spring.
Also this knife has a small hole where You thought a pin should be.
But when I look at the handle, this hole just goes through the hande but not through the back spring.
As I mentioned already the back spring only holds up against the handle.

Sory for not beeing able to go on with the discussion but I will be picked up now.

Best regards, Helge

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

3rd May 2009, 02:23 PM	#8
ingelred Member Join Date: Dec 2004 Location: Moenchengladbach, Germany Posts: 62	Hello Gav, sorry for not showing You the picture I refer to but I have very little time at the moment. Concerning slip joint, okay, let's call it simple back spring. I have also a Albacete made Navaja with a simple back spring and no real locking system. This back spring holds up on the handle which is made one-piece, so no second pin for the back spring. Also this knife has a small hole where You thought a pin should be. But when I look at the handle, this hole just goes through the hande but not through the back spring. As I mentioned already the back spring only holds up against the handle. Sory for not beeing able to go on with the discussion but I will be picked up now. Best regards, Helge