|
23rd March 2009, 11:31 PM
|
#5 |
|
Member
Join Date: Mar 2006
Location: Room 101, Glos. UK
Posts: 4,224
|
 covering removed. socket has a split seam that runs up one side to the start of the square section. the end of the socket has a steel ring 3/4" dia by 7/16" wide around it which is not split. the socket spilt runs up to one of the flats of the sq. section where it stops in a fold that has been flattened when the sq. part was forged. there is no hole for a fastner and no markings... |
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Threaded Mode