keris blade for comment.

BSMStar · 11th April 2005, 01:23 PM

Hi All,

Let me assure you (and I guess I did not explain myself well

) that I would not attempt to etch and stain a "good" blade.

Rick, I fully agree with you. But let me ask a question... If the Javanese sell a keris in plastic dress (yes the sheath and hilt are plastic) to the "tourist" market, it is rusty and has no warangan stain left, do they consider it to be junk?

To me, the blade may be early 20c or late 19c, but I am not an expert.

I have no intention to grind, sand or polish the blade. I just want to remove the rust and restain it. As I have stated before, less is more... and I have etched my share of iron meteorites and I have not lost one yet

The only question in my mind is the staining... I may end up with a totally black blade (but that would be an improvement over its current condition) of course I will stain it slowly and stop the process if I need to (etching I have done, staining is a new thing for me with a keris). I do not foresee damaging the blade in any way; the stain can be removed by a proper acid etch again. Then I would have a clean shiny blade that would need to be properly stained.

I will post pictures as my schedule allows.

FYI, LabanTayo has seen this keris.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11th April 2005, 01:23 PM	#27
BSMStar Member Join Date: Jan 2005 Location: Kansas City, MO USA Posts: 312	Hi All, Let me assure you (and I guess I did not explain myself well ) that I would not attempt to etch and stain a "good" blade. Rick, I fully agree with you. But let me ask a question... If the Javanese sell a keris in plastic dress (yes the sheath and hilt are plastic) to the "tourist" market, it is rusty and has no warangan stain left, do they consider it to be junk? To me, the blade may be early 20c or late 19c, but I am not an expert. I have no intention to grind, sand or polish the blade. I just want to remove the rust and restain it. As I have stated before, less is more... and I have etched my share of iron meteorites and I have not lost one yet The only question in my mind is the staining... I may end up with a totally black blade (but that would be an improvement over its current condition) of course I will stain it slowly and stop the process if I need to (etching I have done, staining is a new thing for me with a keris). I do not foresee damaging the blade in any way; the stain can be removed by a proper acid etch again. Then I would have a clean shiny blade that would need to be properly stained. I will post pictures as my schedule allows. FYI, LabanTayo has seen this keris.