Quote:
Originally Posted by MichaelZWilliamson
Heat will break the epoxy down, if you can first dismount the hilt by driving the pin. I'm not suggesting you should, just that's how it can be done.
|
Old thread I know, but as long as it has been brought back to life, I thought to add this foot note to the restoration and repair portion of this thread. JB Weld is designed to be heat resistant to the point it has been used to repair cracked engine blocks. It will not soften noticeably at a heat that will not destroy the sword hilt. It is also fairly wear-resistant. I have seen it used on large residential lawn mowers to repair the drive pully. the repair held for a decade. Ariel was right about the Dremel tool, chisels. and file/rasps being the way to remove the epoxy.
BTW
Francantolin, what became of this sword?
30th May 2023, 03:39 PM
Threaded Mode