Kris hilt problems, solution anybody?

A. G. Maisey · 10th May 2014, 07:20 PM

There are a few fixes for hole bigger than tang.

Where the tang is very thin, you can make a miniature cone out of thin steel, a piece of old tin can is the sort of material to use. Fit it to the tang and hold it in place with damar or jabung, or even epoxy resin.

If the problem is a far too big hole in the tang, just plug the hole with a dowel, glue in place, and redrill.

I prefer knitting wool as the material to use for a friction fit of tang to hilt, because it compresses. Fabric and the various twines do not compress to the same degree as wool. It is pretty easy to split a hilt if you force it on.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10th May 2014, 07:20 PM	#6
A. G. Maisey Member Join Date: May 2006 Posts: 7,015	There are a few fixes for hole bigger than tang. Where the tang is very thin, you can make a miniature cone out of thin steel, a piece of old tin can is the sort of material to use. Fit it to the tang and hold it in place with damar or jabung, or even epoxy resin. If the problem is a far too big hole in the tang, just plug the hole with a dowel, glue in place, and redrill. I prefer knitting wool as the material to use for a friction fit of tang to hilt, because it compresses. Fabric and the various twines do not compress to the same degree as wool. It is pretty easy to split a hilt if you force it on.