How to tighten a Kaskara hilt?

blue lander · 27th January 2014, 06:27 PM

I don't think the blade has any markings. I attached a picture of what looked like markings on the blade at first, but I think they're just failed laminations or flaws in the steel. They're only on one side of the blade. The hilt does taper, but the ends aren't very well shaped.

I don't know if you can tell anything from the kind of rings used on the scabbard, but I included a picture anyways. They have a channel running down the middle of them.

Edster · 28th January 2014, 12:45 AM

I have a feeling that the blade is "locally" made from ferrous metal other than spring steel. How does it sound when you tap the tip on a hard surface; a kind of a ring or a dull thud-like sound?

Scabbards are made by a separate craft guild from sword and knife makers. The rings are likely made from scrap metal even nails bent in a crude circle. Your rings are interesting, but probably not diagnostic. Likely made from what useful metal on hand.

Take care,
Ed

blue lander · 28th January 2014, 02:49 PM

It rings a little, but it's mostly a dull "thunk". The very loose hilt might be contributing to that, though.

27th January 2014, 06:27 PM	#1
blue lander Member Join Date: Nov 2013 Posts: 456	I don't think the blade has any markings. I attached a picture of what looked like markings on the blade at first, but I think they're just failed laminations or flaws in the steel. They're only on one side of the blade. The hilt does taper, but the ends aren't very well shaped. I don't know if you can tell anything from the kind of rings used on the scabbard, but I included a picture anyways. They have a channel running down the middle of them. Attached Images

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

28th January 2014, 12:45 AM	#2
Edster Member Join Date: Oct 2010 Posts: 449	I have a feeling that the blade is "locally" made from ferrous metal other than spring steel. How does it sound when you tap the tip on a hard surface; a kind of a ring or a dull thud-like sound? Scabbards are made by a separate craft guild from sword and knife makers. The rings are likely made from scrap metal even nails bent in a crude circle. Your rings are interesting, but probably not diagnostic. Likely made from what useful metal on hand. Take care, Ed

28th January 2014, 02:49 PM	#3
blue lander Member Join Date: Nov 2013 Posts: 456	It rings a little, but it's mostly a dull "thunk". The very loose hilt might be contributing to that, though.