Oh yes!

[rickystl]

Originally Posted by RDGAC

'ello 'ello 'ello, I recognise that! That musket was for sale at the Antiques Storehouse, where I got my first, about a year back. I seem to recall you were going to get a barrel liner put in her - how'd that pan out?

Hello. Yes, that's where I bought it. Took forever to get a proper invoice from the owner. After I received the gun (with about 1/4" of paperwork) I noticed it was missing the whole nipple/drum assembly. Had I known you then, I would have asked you to inspect it for me before I bought it. But, it's OK. I can make a new drum/nipple assembly. I have not started to rebuild this one yet. Too many others I'm working on. The barrel on mine is plain and fairly well pitted. So it's a good candidate to do this. I would not do it with your barrel. I wouldn't want to risk the decoration/steel on the barrel.
Your Lock: Where the hammer screw would normally be, your's appears to be a pin/washer assemble held tight from the INSIDE of the lock. But not sure. If you remove the two scews from the stirrup (the semi-U shaped item) you can probably tell how the hammer is held on. I would first use some good penetrating oil on those screws, and let it sit for a few days.
Your's should clean up very well. Rick.