British Eat India Co. Cavalry Pistol

Richard G · 12th May 2016, 01:29 PM

Hello Rick,
I have Harding's 'Introduction to EIC Smallarms' which I have dug out and the following is clear, much of which you have already surmised.
The oficial EIC flintlock to percussion converted lock was only for muskets. It seems the EIC did not convert pistols; they went straight from the Baker pattern flintlock to a percussion pattern in 1840. The EIC continued using flintlocks until 1852.
Harding gives the size of the official EIC converted musket lock as 6.8in by 1.25in
EIC Baker pattern flintlock pistol barrels had baluster rings at the breech and should be 9ins long and it seems, of one piece. The lock should measure 5.25in by 1in.
The barrels of the 1840 and later percussion pistols did not have baluster turns and were of one piece also, but the nipple 'lump' should be welded to the barrel. An original EIC percussion pistol barrel should have a wealth of markings beneath.
The crown over 3 is an inspection mark. The examples in Harding's book do not have the little decorative dots either side.
Hope this helps.
Richard
PS Rick, you posted while I was writing. Lets see what happens.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12th May 2016, 01:29 PM	#15
Richard G Member Join Date: Jan 2012 Posts: 411	Hello Rick, I have Harding's 'Introduction to EIC Smallarms' which I have dug out and the following is clear, much of which you have already surmised. The oficial EIC flintlock to percussion converted lock was only for muskets. It seems the EIC did not convert pistols; they went straight from the Baker pattern flintlock to a percussion pattern in 1840. The EIC continued using flintlocks until 1852. Harding gives the size of the official EIC converted musket lock as 6.8in by 1.25in EIC Baker pattern flintlock pistol barrels had baluster rings at the breech and should be 9ins long and it seems, of one piece. The lock should measure 5.25in by 1in. The barrels of the 1840 and later percussion pistols did not have baluster turns and were of one piece also, but the nipple 'lump' should be welded to the barrel. An original EIC percussion pistol barrel should have a wealth of markings beneath. The crown over 3 is an inspection mark. The examples in Harding's book do not have the little decorative dots either side. Hope this helps. Richard PS Rick, you posted while I was writing. Lets see what happens.