Help with Identification please

imas560 · 1st September 2010, 12:08 AM

I read in a couple of posts about heating with a blowtorch but I'll give the candle a go. Also spotted a couple of posts dealing with a hilt that had been glued but I hope it won't come to that.

I am planning on the following process:
1. remove hilt
2. degrease
3. soak in juice
then daily (well as close to daily as possible)
4. scrub with toothbrush
5. re-soak
repeat till blade cleaned
6. lime juice and arsenic (optional depending on obtaining arsenic)
7. oil
8. re-hilt

What is a good indicator that a blade has been sufficiently cleaned to treat with lime and arsenic?
How frequently to change out the juice?
Also posts mention keris oil, where can this be sourced? and what is it's closest readily available equivalent?
Many thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

1st September 2010, 12:08 AM	#26
imas560 Member Join Date: Aug 2010 Posts: 180	I read in a couple of posts about heating with a blowtorch but I'll give the candle a go. Also spotted a couple of posts dealing with a hilt that had been glued but I hope it won't come to that. I am planning on the following process: 1. remove hilt 2. degrease 3. soak in juice then daily (well as close to daily as possible) 4. scrub with toothbrush 5. re-soak repeat till blade cleaned 6. lime juice and arsenic (optional depending on obtaining arsenic) 7. oil 8. re-hilt What is a good indicator that a blade has been sufficiently cleaned to treat with lime and arsenic? How frequently to change out the juice? Also posts mention keris oil, where can this be sourced? and what is it's closest readily available equivalent? Many thanks