One of the world's earliest known wheel-lock mechanisms, ca. 1535-40

Matchlock · 19th September 2008, 06:18 PM

When enquiring about the wheel-lock ingintion on the world wide web you will almost inevitably bump into one story: the legend of a certain Johann Kiefuß of Nuremberg, who is said to have invented to wheel-lock in 1517 exactly.
Sadly, this silly mistake made by writers in the second half of the 19th century when historical weaponry was still taking its first steps in science, is repeated again and again. Still, it is nothing but a story.

As scholars like Claude Blair pointed out decades ago, the wheel-lock ignition principle had been well known since at least the later years of the 15th century and depicted in scrapbooks like Leonardo da Vinci's Codex Atlanticus, although not as a mechanical part for igniting a firearm but as a tinder lighter used in everyday life.

To cut a long story short, the political leaders like Maximilian I very soon grabbed the completely new and dangerous potential of this self-igniting mechanism. For the first time in history, the wheel-lock enabled an assailant to make an attempt out of the blue, with no fondling with either open fire or a smoldering match required! Consequently, Maximilian I released a prohibition edict on self-igniting guns in 1518, I think, which Maximilian's follower, Charles V - though being an avid wheel-lock fan himself - , kept up until his retirement in the mid-1550's.

Due to such restrictions, the number of wheel-locks legally produced was, of course, actually very limited during the first half of the 16th century while increasing rapidly from ca. the 1560's when it was no longer banned.

This stunningly well-preserved sample is almost certainly of North Italian (Brescia?) make and can be dated to ca. 1535-40 on the ground of stylistc features to be found on similar locks dug out from bogs in Hungary; they were part of the equipment of a boat with harquebusiers on board which shipwrecked on the Danube near Komorn in 1541.

The piece of pyrites screwed in the jaws of the dog was pressed on the wheel by a spring, and the wheel was wound up against the main spring. If released by pulling the trigger - rarely enough, the trigger is an integral part of the lock plate here which suggests that this lock was meant to fire a combination weapon like, e.g., a battle hammer, combined with a barrel - the main spring would quickly snap back and force the spinning wheel to produce sparks from the pyrites. These sparks immediately ignited to priming powder in the pan where they were produced; this flame went right through the touch hole in the barrel and made the actual load explode.

I attach a b/w image of a small combined battle hammer and wheel-lock gun preserved in the collections in Schloss Ambras, The Tyrol, in order to convey an impression of what the whole piece may have looked like.

Enjoy this finely file-decorated and extremely rare lock as a sample of the arts and crafts of the early lock-smiths!

Matchlock (Michael)

TVV · 20th September 2008, 06:20 PM

Matchlock,

My knowledge does not allow me to participate in your threads with any observations or even intelligent questions, but I just wanted to say that I appreciate the content you share with us. Early firearms are fascinating and I know I have learned many new things from your posts.

Thank you,

Teodor

Matchlock · 20th September 2008, 06:51 PM

Teodor,

I think all of us joined this forum in order to learn from people who have gathered detailed knwolegde by experience, each in his own niche.

It is a great pleasure to a newcomer like myself to receive so much kind acceptance by fellow members, and very awarding as well.

Thank you, folks, sharing with you is fun!

Matchlock/Michael

Pukka Bundook · 26th September 2008, 03:05 PM

Michael,
Very interesting lock.
I have not seen a sear/trigger that works quite like this one. very simple, but foolproof as well!
If I ever "get 'round" to making a wheellock, this is something to try!
(Been thinking about it forever, but something always gets in the way..)

Thanks for posting the pics.

Richard.

Marcus den toom · 5th March 2014, 05:04 PM

Hi Michael,

I saw this thread when browsing through old threads (with a dust mask on). A beautiful piece of engineering

But i don't really understand how the pancover works

Did you have to manualy open the pan before the dog with pyrith is pressed against the wheel?

Hopefully this enquiry will put this highly interesting subject back on the map

Fernando K · 6th March 2014, 02:36 PM

Hi marcus

The question is addressed to Matchlock, but let me answer you. The wheel has a cavity in which a lever integral with the pancover, who gets into the cavity when the wheel is mounted, and primed the bread is introduced. When the wheel starts to turn, forces the lever outside the cavity, opening the bread. In turn, this unsightly spring on top of the lock remains closed pancover.

Affectionately. Fernando K

(Sorry for the translator)

19th September 2008, 06:18 PM	#1
Matchlock (deceased) Join Date: Sep 2008 Location: Bavaria, Germany - the center of 15th and 16th century gunmaking Posts: 4,310	One of the world's earliest known wheel-lock mechanisms, ca. 1535-40 When enquiring about the wheel-lock ingintion on the world wide web you will almost inevitably bump into one story: the legend of a certain Johann Kiefuß of Nuremberg, who is said to have invented to wheel-lock in 1517 exactly. Sadly, this silly mistake made by writers in the second half of the 19th century when historical weaponry was still taking its first steps in science, is repeated again and again. Still, it is nothing but a story. As scholars like Claude Blair pointed out decades ago, the wheel-lock ignition principle had been well known since at least the later years of the 15th century and depicted in scrapbooks like Leonardo da Vinci's Codex Atlanticus, although not as a mechanical part for igniting a firearm but as a tinder lighter used in everyday life. To cut a long story short, the political leaders like Maximilian I very soon grabbed the completely new and dangerous potential of this self-igniting mechanism. For the first time in history, the wheel-lock enabled an assailant to make an attempt out of the blue, with no fondling with either open fire or a smoldering match required! Consequently, Maximilian I released a prohibition edict on self-igniting guns in 1518, I think, which Maximilian's follower, Charles V - though being an avid wheel-lock fan himself - , kept up until his retirement in the mid-1550's. Due to such restrictions, the number of wheel-locks legally produced was, of course, actually very limited during the first half of the 16th century while increasing rapidly from ca. the 1560's when it was no longer banned. This stunningly well-preserved sample is almost certainly of North Italian (Brescia?) make and can be dated to ca. 1535-40 on the ground of stylistc features to be found on similar locks dug out from bogs in Hungary; they were part of the equipment of a boat with harquebusiers on board which shipwrecked on the Danube near Komorn in 1541. The piece of pyrites screwed in the jaws of the dog was pressed on the wheel by a spring, and the wheel was wound up against the main spring. If released by pulling the trigger - rarely enough, the trigger is an integral part of the lock plate here which suggests that this lock was meant to fire a combination weapon like, e.g., a battle hammer, combined with a barrel - the main spring would quickly snap back and force the spinning wheel to produce sparks from the pyrites. These sparks immediately ignited to priming powder in the pan where they were produced; this flame went right through the touch hole in the barrel and made the actual load explode. I attach a b/w image of a small combined battle hammer and wheel-lock gun preserved in the collections in Schloss Ambras, The Tyrol, in order to convey an impression of what the whole piece may have looked like. Enjoy this finely file-decorated and extremely rare lock as a sample of the arts and crafts of the early lock-smiths! Matchlock (Michael) Attached Images

20th September 2008, 06:20 PM	#2
TVV Member Join Date: Dec 2004 Location: Bay Area Posts: 1,619	Matchlock, My knowledge does not allow me to participate in your threads with any observations or even intelligent questions, but I just wanted to say that I appreciate the content you share with us. Early firearms are fascinating and I know I have learned many new things from your posts. Thank you, Teodor

20th September 2008, 06:51 PM	#3
Matchlock (deceased) Join Date: Sep 2008 Location: Bavaria, Germany - the center of 15th and 16th century gunmaking Posts: 4,310	Teodor, I think all of us joined this forum in order to learn from people who have gathered detailed knwolegde by experience, each in his own niche. It is a great pleasure to a newcomer like myself to receive so much kind acceptance by fellow members, and very awarding as well. Thank you, folks, sharing with you is fun! Matchlock/Michael

26th September 2008, 03:05 PM	#4
Pukka Bundook Member Join Date: Jan 2007 Posts: 803	Michael, Very interesting lock. I have not seen a sear/trigger that works quite like this one. very simple, but foolproof as well! If I ever "get 'round" to making a wheellock, this is something to try! (Been thinking about it forever, but something always gets in the way..) Thanks for posting the pics. Richard.

5th March 2014, 05:04 PM	#5
Marcus den toom Member Join Date: Jun 2013 Location: Netherlands Posts: 525	Hi Michael, I saw this thread when browsing through old threads (with a dust mask on). A beautiful piece of engineering But i don't really understand how the pancover works Did you have to manualy open the pan before the dog with pyrith is pressed against the wheel? Hopefully this enquiry will put this highly interesting subject back on the map

6th March 2014, 02:36 PM	#6
Fernando K Member Join Date: Apr 2010 Posts: 669	Hi marcus The question is addressed to Matchlock, but let me answer you. The wheel has a cavity in which a lever integral with the pancover, who gets into the cavity when the wheel is mounted, and primed the bread is introduced. When the wheel starts to turn, forces the lever outside the cavity, opening the bread. In turn, this unsightly spring on top of the lock remains closed pancover. Affectionately. Fernando K (Sorry for the translator)