![]() |
![]() |
#1 |
Member
Join Date: Dec 2004
Location: Kernersville, NC, USA
Posts: 793
|
![]()
Hi folks,
I posted pics of this sword on the old forum http://www.vikingsword.com/ubb/Forum1/HTML/002539.html The blade came cleaned by a previous owner. I've been curious about the composition of the blade steel, to today i gave it a mild etch. Turns out it's a monosteel, but very nicely differentially hardened. It's not a chisel grind, but a full flat grind from the spine to the edge. It's starp too. ![]() ![]() Steve ![]() |
![]() |
![]() |
![]() |
#2 |
(deceased)
Join Date: Dec 2004
Location: East Coast USA
Posts: 3,191
|
![]()
Steve
I luv it super etch job! Lew |
![]() |
![]() |
![]() |
#3 |
Member
Join Date: Dec 2004
Location: VISAYAS and MINDANAO
Posts: 169
|
![]()
Very nice!!!!
Looks like the kind fighting bolo or talibong I would use in a serious situation... ![]() Love that handguard... |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Dec 2004
Location: Kernersville, NC, USA
Posts: 793
|
![]()
Zelbone,
You bet! It's a zero grind. It's flat from the spine to the edge and incredibly sharp. In scrubbing it after etching I accidentally flicked my fingernail against the edge. It went through the nail, into the meat, then as I jerked my finger back, cut a quarter inch trough through the end of the nail. ![]() Steve |
![]() |
![]() |
![]() |
|
|