Meteoric Patrem-Made In England...

A. G. Maisey · 8th April 2008, 09:49 AM

Forget grinders and dremels and such like.

The blade features---sogokan, greneng, blumbangan etc---are most easily and most quickly done by (sogokan) roughing out with a small cold chisel, refining with a scraper, and finishing with jewellers files and rifflers. Greneng is most easily cut with jewellers files. The easiest way to get the right contours in the blade is with a scraper.

Yeah, yeah---I know almost everybody working today uses grinders, but have a close look at the detail sometime, and then look at something that is attributed to Kinom, or one of the other past greats. There is only so much flexibility in a grinder, and it is impossible to cut the correct contours in sogokan with a grinder.

Of course, using non mechanical tools increases working time, and thus increases price, and 99.9% of buyers cannot tell you what the correct contours are anyway, so who is going to pay 5 or 6 times as much for something, if they cannot see any difference between it and something made with a grinder?

It takes about 40 hours for a skilled craftsman to cut correct sogokan to only one side of a blade.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

8th April 2008, 09:49 AM	#13
A. G. Maisey Member Join Date: May 2006 Posts: 7,047	Forget grinders and dremels and such like. The blade features---sogokan, greneng, blumbangan etc---are most easily and most quickly done by (sogokan) roughing out with a small cold chisel, refining with a scraper, and finishing with jewellers files and rifflers. Greneng is most easily cut with jewellers files. The easiest way to get the right contours in the blade is with a scraper. Yeah, yeah---I know almost everybody working today uses grinders, but have a close look at the detail sometime, and then look at something that is attributed to Kinom, or one of the other past greats. There is only so much flexibility in a grinder, and it is impossible to cut the correct contours in sogokan with a grinder. Of course, using non mechanical tools increases working time, and thus increases price, and 99.9% of buyers cannot tell you what the correct contours are anyway, so who is going to pay 5 or 6 times as much for something, if they cannot see any difference between it and something made with a grinder? It takes about 40 hours for a skilled craftsman to cut correct sogokan to only one side of a blade.