Kampilan Question

potapych · 13th July 2007, 09:09 AM

Hi Kai,

Hope this helps, it's the best I could do being that it's night time here. The reverse taper is about equivalent to the front edge taper, (a little over 1/4 the blade width) and runs for about 8 1/2" (or 21.6 cm) back from the tip. It is as sharp as the front (very) and there is no indication it has ever been any different.The blade measures 29 5/8" (or 75.75 cm). I'll try for a daylight shot later.

It's scabbard also conforms to the blade profile but that in itself is not so compelling as they were often, (as I'm sure you know), discarded in the heat of things and later replaced.

Best,

Ray

13th July 2007, 09:09 AM	#13
potapych Member Join Date: Sep 2005 Location: Left Coast, USA Posts: 14	Hi Kai, Hope this helps, it's the best I could do being that it's night time here. The reverse taper is about equivalent to the front edge taper, (a little over 1/4 the blade width) and runs for about 8 1/2" (or 21.6 cm) back from the tip. It is as sharp as the front (very) and there is no indication it has ever been any different.The blade measures 29 5/8" (or 75.75 cm). I'll try for a daylight shot later. It's scabbard also conforms to the blade profile but that in itself is not so compelling as they were often, (as I'm sure you know), discarded in the heat of things and later replaced. Best, Ray Attached Images Last edited by potapych; 13th July 2007 at 09:26 AM.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode