Good news /bad news Tulwar.

Gt Obach · 28th February 2007, 03:32 PM

Hi Richard
Its up to you if you want to leave the fullers

if you bring it up to 600 grit... with fresh papers.. have a strong light shine down on the flat of the blade..... get your eyes close the the blade and you should be able to see if its patternweld or wootz blade... its very subtle but there.... unless you burnish the blade by overloading your sand paper with grindings..

for me.... i'd polish out the chips... as they could be starting points for cracks in the blade if you use it for cutting... but if you don't use it for cutting... then leave them

a truly sharp sword has a certain magic...

Greg

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

28th February 2007, 03:32 PM	#24
Gt Obach Member Join Date: Mar 2005 Posts: 116	Hi Richard Its up to you if you want to leave the fullers if you bring it up to 600 grit... with fresh papers.. have a strong light shine down on the flat of the blade..... get your eyes close the the blade and you should be able to see if its patternweld or wootz blade... its very subtle but there.... unless you burnish the blade by overloading your sand paper with grindings.. for me.... i'd polish out the chips... as they could be starting points for cracks in the blade if you use it for cutting... but if you don't use it for cutting... then leave them a truly sharp sword has a certain magic... Greg