Is this blade pattern welded damascus or something even better?

mross · 11th December 2006, 04:34 PM

The two I was thinking about where Manfred Sachse "Damascus Steel" and L.S. Figiel "On Damascus Steel". In particular Sachse pg 180 plate 316. It could be either, while odd for pattern welding, it could be done. If it's wootz and the pattern does look similiar to some wootz, the grain seems too large/crude. Have you posted it on Sword Forum? Rich Furrer/Kevin Cashen are on that list and the knows their stuff. Also if you can on Don Fogg's site you will find some of the best pattern welders and makers around. It could be shear steel. It is definitly cool to look at though. Thanks for sharing. If you post it else where and get a more definitive answer please share.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11th December 2006, 04:34 PM	#6
mross Member Join Date: Jan 2005 Posts: 478	The two I was thinking about where Manfred Sachse "Damascus Steel" and L.S. Figiel "On Damascus Steel". In particular Sachse pg 180 plate 316. It could be either, while odd for pattern welding, it could be done. If it's wootz and the pattern does look similiar to some wootz, the grain seems too large/crude. Have you posted it on Sword Forum? Rich Furrer/Kevin Cashen are on that list and the knows their stuff. Also if you can on Don Fogg's site you will find some of the best pattern welders and makers around. It could be shear steel. It is definitly cool to look at though. Thanks for sharing. If you post it else where and get a more definitive answer please share.