Shotley Bridge smallsword

urbanspaceman · 24th March 2022, 12:35 PM

I recently acquired this Shotley Bridge smallsword.
During the six years I have been researching Shotley swordmakers I have only ever seen three (including this one).
The hilts of the other two were also brass but not figured and pierced.
When I was photographing the sword I discovered that the lower surfaces of the hilt were copper plated. At first I assumed the upper surfaces had not been plated and they had achieved a two-tone effect, but closer inspection revealed that some of the upper surfaces in areas un-rubbed were also copper plated.
I believe, back then, they referred to this copper plating as Japanning, and it was vicious process involving the burning of a mercury substrate with consequent poisonous fumes.
In keeping with the copper bindings it is now obvious the entire hilt was copper plated.
Is this a common effect on smallsword hilts?

24th March 2022, 12:35 PM	#1
urbanspaceman Member Join Date: Sep 2017 Location: Tyneside. North-East England Posts: 532	Shotley Bridge smallsword I recently acquired this Shotley Bridge smallsword. During the six years I have been researching Shotley swordmakers I have only ever seen three (including this one). The hilts of the other two were also brass but not figured and pierced. When I was photographing the sword I discovered that the lower surfaces of the hilt were copper plated. At first I assumed the upper surfaces had not been plated and they had achieved a two-tone effect, but closer inspection revealed that some of the upper surfaces in areas un-rubbed were also copper plated. I believe, back then, they referred to this copper plating as Japanning, and it was vicious process involving the burning of a mercury substrate with consequent poisonous fumes. In keeping with the copper bindings it is now obvious the entire hilt was copper plated. Is this a common effect on smallsword hilts? Attached Images