Help with Identification please

imas560 · 5th September 2010, 07:08 AM

Hello all,
Today being Father's Day in N.Z. I was given a free allotment in the space time continuum to "go play with your blades". So have embarked on step 1 of cleaning up my newly acquired keris. I have confirmed the sororan area from the details picture at Paul's Keris page.
http://pachome1.pacific.net.sg/~dspf/details.jpg
The hilt is on very tight (no movement).
I setup with my candle and keris. I wrapped the handle with a bit of towel rag just in case flame/heat got too close as this is my first time.

I got the candle going and then played the flame along the sororan area.

I did encounter a slight problem, there were a couple of spots on the blade (nearer to the handle) where the flame was drawn to the blade and I had to move the blade away quickly.

I applied the candle heat until the blade got warm where I was holding it. The blade near the handle did get hotter than a warm to the touch level. I let it cool and then re-applied heat but not as long as the first attempt.
Two attempts was enough for today.
The handle had slightly freed up in a sideways direction but no perceptible movement in a direction away from the blade.

5th September 2010, 07:08 AM	#21
imas560 Member Join Date: Aug 2010 Posts: 180	Step 1: Hilt Removal Hello all, Today being Father's Day in N.Z. I was given a free allotment in the space time continuum to "go play with your blades". So have embarked on step 1 of cleaning up my newly acquired keris. I have confirmed the sororan area from the details picture at Paul's Keris page. http://pachome1.pacific.net.sg/~dspf/details.jpg The hilt is on very tight (no movement). I setup with my candle and keris. I wrapped the handle with a bit of towel rag just in case flame/heat got too close as this is my first time. I got the candle going and then played the flame along the sororan area. I did encounter a slight problem, there were a couple of spots on the blade (nearer to the handle) where the flame was drawn to the blade and I had to move the blade away quickly. I applied the candle heat until the blade got warm where I was holding it. The blade near the handle did get hotter than a warm to the touch level. I let it cool and then re-applied heat but not as long as the first attempt. Two attempts was enough for today. The handle had slightly freed up in a sideways direction but no perceptible movement in a direction away from the blade.