FORMING HOT METAL WITH BARE HANDS

[Richard Furrer]

Originally Posted by A. G. Maisey

Which I did. Once.

Don't know anything about leidenfrost.

Do know a little bit about fire and iron.

Addition:-

Just checked the liedenfrost thing. Looks like that's what was happening. Now I know its name.

As someone who has unintentionally grabbed,not gently touched nor bumped, but put a hand sqeeze on an orange bar of steel in a very unfocused moment.....I would say that it is all legend. It took me three weeks to heal enough to really use that hand again.
At a good welding heat 1% carbon steel is about as close to dripping liquid as it will get...and still more resistant to our flesh than we are to it.

That is not to say that we can not bend it or twist it, but we can not "forge it"...apply enough pressure to leave an indentation the bar...no way. In blade thicknesses it cannot be done, but I would think that one could ripple a bar of 1/16" thick steel without much issue, but leaving indentations in a 1/8" thick or more bar..no.

I have seen blades which had "lip prints" and "finger prints" in the steel..done with tools not flesh I am sure.


As to the vapor barrier...yes it can help a lot with lessening the severity of casual contact burns, HOWEVER, once you push hard enough to break through the vapor....which one would need to do to forge, well...that is a different story.....ever see meat on a hot grill? That was my hand...made the same sound too.

Ric