13th May 2015, 12:32 AM | #1 |
Member
Join Date: May 2006
Posts: 6,898
|
Mendak
Most keris have a little ring in between the hilt and the blade base, in Jawa this is called the mendak, or uwer, or wewer. Mendak is the common term.
In recent years it has been very, very difficult to obtain a suitable old mendak when one is needed to complete a keris in old dress. In fact, many keris collectors who have begun to collect during, say, the last 5 years, have never even seen an old mendak. Here are a couple of pictures some old mendak, mostly Javanese and Madurese. |
17th May 2015, 02:59 PM | #2 |
Member
Join Date: Jun 2009
Posts: 1,740
|
Hello Alan,
Very nice and rare collection! Although this subject was already raised in the past, could you please show us some representative and rare specimens of mendaks from Central Java (Yogyakarta and Solo), Cirebon/ West Java, East Java, and Madura as the distinction is not clear for most of us. Thank you and best regards |
17th May 2015, 11:39 PM | #3 |
Member
Join Date: May 2006
Posts: 6,898
|
Not clear to me either Jean.
Nor to anybody I know in Solo. My personal opinion is that whilst some things are pretty obvious and known to virtually everybody, such as the distinction between Jawa and Madura, just about everything else is up for grabs. In fact, going back a long time to when I got my first few keris, keris that had been collected mostly in Batavia (Jakarta) in about 1920, most of those keris had no mendak at all. I know that some mendak patterns are accepted by many people as Jogja, and others as Solo, but then you get the situation where you find something that has previously been identified as Solo being identified as Jogja, because it is on a big Jogja jejeran, rather than a small one. For as long as I've been going to Indonesia, which is 40 odd years, the distinction that seems to be most usually made is between Central Jawa and East Jawa/Madura. East Jawa Madura are generally a little bit bigger, and are hollow, Central Jawa are fabricated and a little bit smaller, but in practice it seems as if the general rule for use is that if the mendak fits the jejeran, and looks OK, that is what gets used. If we look at keris that we know to be pre-1700, what we find is that a lot of these keris do not have mendak, even though they would have been collected as virtually new keris. Others of these early keris have a quite high fabricated mendak, with some applied ornamentation. Then we have the rare iron mendaks, which I think probably belonged with the North Coast iron seluts, and I believe are a direct continuation of the metuk which preceded the mendak. Sorry Jean, I cannot answer your question. Actually these mendak are not really a collection, they're just a few of the more interesting ones I have, I've probably got about 500 mendak and wewer, all stored in bottles. |
18th May 2015, 11:06 AM | #4 |
Member
Join Date: May 2014
Posts: 116
|
Perhaps this is a foolish question, but what lies behind the rarity of these objects? Have they been ignored, or unremarked by collectors, until now? They don't seem all that fragile so they ought to survive, are they being sold to jewelers when the family hits dire straits? What do you say?
|
18th May 2015, 02:55 PM | #5 |
Member
Join Date: May 2006
Posts: 6,898
|
The new ones are not rare, and you can buy really cheap ones for almost nothing --- good ones cost, sometimes cost big when we are talking top quality and premium materials, but the old ones seem to have been used up.
By "used up" I mean that they have broken, or been lost and the quite small existing stock has been re-distributed to existing old keris. I've often had old keris in my hands that didn't have any mendak, or had a junk modern one, or if an old mendak was fitted, it was crushed and broken. Over a 50 year period I've simply bought every halfway decent old mendak that I've come across. That's why I have so many. Not "collection", more "accumulation". Many old mendak were pretty fragile. The iron ones, cast bronze and cast brass were not fragile, but there were very few of those, however, the fabricated ones would in many cases have crushed and broken if the blade hit a bone when thrust. The hollow East Jawa/Madura ones you can crush between your fingers. |
18th May 2015, 11:16 PM | #6 | |
Member
Join Date: Nov 2006
Location: The Netherlands
Posts: 2,225
|
Quote:
Nive collection btw. Allways good to bring this under the attention. I really dislike the cheap mendak that are sometimes seen on nice old keris. Best regards, Willem |
|
19th May 2015, 12:05 AM | #7 |
Member
Join Date: May 2006
Posts: 6,898
|
But there is a reason for those cheapy mendak Willem.
A good brand new mendak can cost more than a pretty reasonable sort of keris. A good old mendak can cost more than a decent keris. It wasn't always like this, but it is now. If somebody in the keris trade in Indonesia wants to sell a good keris, and by keris, I mean the keris itself, not including the dress, they limit their buyers by dressing that keris in premium component parts, so they either sell the blade bare, or use cheap, low quality dress. This permits the new owner to dress the keris as he sees fit. However, if he wishes to use older dress on the old keris, he may take quite some time to assemble the quality parts he needs, and one of the more difficult parts is the mendak. |
19th May 2015, 01:24 AM | #8 |
Member
Join Date: Dec 2004
Location: Ann Arbor, MI
Posts: 5,503
|
What kind of mendak would fit a Pathani Tajong with a Swaasa cover for the "nose"?
Are those available? How much would they cost? |
19th May 2015, 04:29 AM | #9 | |
Keris forum moderator
Join Date: Aug 2006
Location: Nova Scotia
Posts: 7,127
|
Quote:
I'd prefer to keep specific discussion of the cost of things off the boards. |
|
20th May 2015, 01:13 AM | #10 |
Member
Join Date: Dec 2004
Location: Ann Arbor, MI
Posts: 5,503
|
Alan repeatedly mentioned high prices of old mendaks.
I just asked him to elaborate on the already expressed qualitative view by adding some quantification. Nobody here is buying or selling anything specific; we are talking about generalities. Something along the lines: a Swaasa pendokok may cost between $ 200 - 1000. Nothing more. |
20th May 2015, 03:45 AM | #11 |
Member
Join Date: May 2006
Posts: 6,898
|
Ariel, I'm talking about mendak, not Balinese wewer nor Peninsula pendongkok.
As with all things prices depend upon who is buying and who is selling, where the transaction takes place and at what market level one buys:- a collector in London or New York will pay more than a market retailer who sells in Central Jawa. |
20th May 2015, 08:10 AM | #12 | |
Keris forum moderator
Join Date: Aug 2006
Location: Nova Scotia
Posts: 7,127
|
Quote:
|
|
1st March 2018, 12:58 PM | #13 |
Member
Join Date: Nov 2017
Posts: 205
|
Pick up this old topic to introduce a genuine old mendak.
Unsure about the material. Could either be ivory (no schraeger lines spotted) or deer / antler? Small repair needed at the bottom where a chip was broken off. Very white dense from the inside. Any suggestion about it and which handle (Solo / Djogja or even Madura) is best to combine? |
1st March 2018, 04:02 PM | #14 |
Keris forum moderator
Join Date: Aug 2006
Location: Nova Scotia
Posts: 7,127
|
I doesn't look like ivory Paul. Could be bone or antler. Could even be resin from the looks of it. Is there a thick layer of shellac over it?
|
1st March 2018, 06:01 PM | #15 |
Member
Join Date: Nov 2017
Posts: 205
|
Just oiled it and it should soak a bit (it was very dry) so that's why it appears so shiny.The structure is very dense so I doubt if it is from bone.
|
1st March 2018, 06:06 PM | #16 |
Keris forum moderator
Join Date: Aug 2006
Location: Nova Scotia
Posts: 7,127
|
I might suggest that you wipe it dry once you feel it has soaked enough and re-photograph it. The oil is a bit distracting to the subject at hand.
|
2nd March 2018, 03:07 PM | #17 |
Member
Join Date: Nov 2017
Posts: 205
|
More interested to know were it comes from than the material itself.
|
|
|