Ethnographic Arms & Armour - View Single Post

Battara · 7th March 2005, 03:06 PM

I had to make my own gravers out of tempered steel, but small enough to fit into the grooves and re-ingrave the channels. Very time consuming process. And it is not just the depth but the angle of the cuts that is very important.

7th March 2005, 03:06 PM	#7
Battara EAAF Staff Join Date: Dec 2004 Location: Louisville, KY Posts: 7,270	I had to make my own gravers out of tempered steel, but small enough to fit into the grooves and re-ingrave the channels. Very time consuming process. And it is not just the depth but the angle of the cuts that is very important.