Ethnographic Arms & Armour - View Single Post - Dha-Lwe average measurements please

Mark · 13th July 2007, 05:44 PM

Hi Antonio,

Did you check my web site? This dha is on there, but it was an early one, so it might not have the spine widths (I changed the format of the specification section). I'll take some measurements.

I have a couple of this style that are smaller - this one is unusually large and heavy. The proportions stay generally constant, handle-to-blade ratio, spine taper, etc. The taper is very dramatic, reducing by at least half over the first third of the blade length, and reaching essentially the width of the edge at the tip of the blade. PUFF, and others of our Thai collegues, call this a "double taper," as the rate of decrease is greater near the blade than it is approaching the tip, like the profile of the Eiffel Tower. Widths at the base of the blade are typically from round 3 to around 5 mm. This one is especially broad.

The span of the tip (edge to spine, in other words), does vary. This one is at the wide end of the scale. Many reach the maximum span around the last third of the blade.

13th July 2007, 05:44 PM	#3
Mark Member Join Date: Dec 2004 Posts: 987	Hi Antonio, Did you check my web site? This dha is on there, but it was an early one, so it might not have the spine widths (I changed the format of the specification section). I'll take some measurements. I have a couple of this style that are smaller - this one is unusually large and heavy. The proportions stay generally constant, handle-to-blade ratio, spine taper, etc. The taper is very dramatic, reducing by at least half over the first third of the blade length, and reaching essentially the width of the edge at the tip of the blade. PUFF, and others of our Thai collegues, call this a "double taper," as the rate of decrease is greater near the blade than it is approaching the tip, like the profile of the Eiffel Tower. Widths at the base of the blade are typically from round 3 to around 5 mm. This one is especially broad. The span of the tip (edge to spine, in other words), does vary. This one is at the wide end of the scale. Many reach the maximum span around the last third of the blade.