Quote:
Originally Posted by Edster
Marc,
This is off topic, but since you are a blacksmith you no doubt have experience in applying stamps to metal. Your experience could help in identifying dates & origins of imported and locally made blades. The question: would a maker's mark or other stamp be applied with the strike of a hammer to a relative soft sword blade just after forging or after the blade had been quenched and drawn? We see marks attributed to a retailer after a European blade was imported, or maybe as fake marks to impute quality, etc. Also, some marks are a identified as rack or inventory stamps applied in an amory, etc.
Would a sword blade be softer at forte area that may not have been quenched and accept a stamp better? This may be why makers marks are often seen under langets.
Best regards,
Ed
|
Hi Ed
Ian's answer is correct , the steel of a swords blade has to be able to parry a blow from a sword, cut, chop and stab the oposant, so it should not be to hard so it is soft enough to do the cold marking.
As Ian said hot markings are deeper, done with hammer or press.
If i had to choose a place to put the marking on the blade, it would be the ricasso/ forte if their is one or near the crossgard, that area should not be to hard, edge's shoult be harder, not the place to make a mark.
So both techniques where used. Hopefully this answers your question a little
bit.
Best regards
Marc