Quote:
|
Originally Posted by Pinoy Blade Hunter
great collection you have there. i am curious on how you go about ethcing the whole length of the kris blade? i am planning on etching mine as well.
thank you.
|
Thanks Pinoy Blade Hunter!
I have a plastic drafting/drawing tube that I fill with sukang puti. It is long enough to immerse the blade up to the area near the gangya. I then brush vinegar on the exposed gangya from time to time. After a few minutes or hours (depending on the condition of the blade) I remove the blade from the tube and even out the etch by brushing more vinegar on the etch line and gangya. I then immerse it again if necessary, until I get the desired effect.
It's important that you neutralize the blade by washing it with a baking soda slurry after etching. After washing off the slurry, I use WD 40 to protect the blade. Btw, I cover the hilt with cling wrap for protection.
Kind regards,
Fernando/ F. de Luzon