Quote:
|
Originally Posted by ariel
The last pic suggests that the "strips" we're not applied to flat metal ( no trace of welding or other similar technique). Rather, they were hammered out from the other side of the sheet metal, then it was bent and formed into a scabbard fitting.
|
I believe you are correct and the chape made in a more conventional way. I can not easily remove the chape to check the internal surface but there is really no need. As Estcrh said it is an unusual and difficult way to apply the decoration to the throat piece and also that this decoration does not match that on the chape. I wonder if this is a replacent thrat piece or the original was plain and the strips applied in an attempt to match the chape, whatever it is a good piece of workmansip.
Regards
Miguel